![]() ![]() The information I found was more than a silver bullet. I shudder to think about how this job could have gone if I had no access to any further information than what was in the Factory trouble code chart. This is the value of iATN and collaborating in general. It's been several days since returning the car and all is good. When I move the wire just right on B2S2 this happens I replaced the sensor and cleared the code. With the car running I start wiggling and tugging on the sensor wires. It seems that problems with the O2 sensors can cause this code to set. I come across this post in the techhelp archive Ok, now I have something to go on. Since this is my first time with this particular code I decide some iATN research is in order. Ok, I've been doing this long enough to know that I better not replace the ECM just like that without doing some research and testing. The code chart is very short for this code, it says, If you have code P0606 go to step A. A discrepancy in voltage levels between the main cpu and the sub cpu. Free download installation netware 312 programs. The flash went fine, now it's a month later and the Mil is on. They asked me to flash the tcm per toyota bulletin for a shifting issue. ![]() The first time I saw this car was from a referral by my local trans shop. Posted to on 53 Replies The iATN archives helped me on this car so I wanted to contribute back and hope someone else finds this helpful. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |